Skip to main content

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S303-02 Date: 020301

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S303-02 Date: 020301



Knock Sensor - Designation Clarification



S303-02



DATE



03/02



S-Type



MODEL



2000-02 MY S-Type (3.0L) V6



2000 Jaguar S-Type (X200) V6-3.0L Page 94



VIN



3.0L V6 Knock Sensor Designations - Not Based On Cylinder Bank Designations - Clarification



Issue:



It is important to note that the V6 knock sensors are numbered as front and rear - not based on the engine banks. The front knock sensor (1) is



located in the vee at the top of the engine where it senses knocking from bank 2, the left bank (Illustration 1).



The rear knock sensor (2) is located on the right side of the block, above the starter motor (Illustration 2), where it senses knocking from bank 1, the



right bank, where cylinder 1 is located (Illustration 3).



This apparent contradiction must be kept in mind, when using the electrical guides or the DTC summaries.



2000 Jaguar S-Type (X200) V6-3.0L Page 95



^ DTC P0325 applies to the front knock sensor on top of the engine.



^ DTC P0330 applies to the rear knock sensor on the side of the engine block.



Note this correction in your DTC Summary book.



Refer to the cross-reference matrix shown.

Labels:

Comments

Post a Comment

Popular posts from this blog

Integrated Control Panel (FCDIM)

Integrated Control Panel (FCDIM) Diagnostic Trouble Code (DTC) Index Integrated Control Panel (FCDIM) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. 2012 Jaguar XJ (X351) V8-5.0L SC   284 NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed
Post a Comment
Read more

Adaptive Damping Module (SUMB)

Adaptive Damping Module (SUMB) Diagnostic Trouble Code (DTC) Index Adaptive Damping Module (SUMB) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra
Post a Comment
Read more