Skip to main content

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S204-02 Date: 990601

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S204-02 Date: 990601



Wheel Nut - Torque Specification Clarification



S204-02



DATE 6/99



MODEL



2000 MY-ON S-TYPE



VIN



2000 Jaguar S-Type (X200) V6-3.0L Page 62



L00001-ON



Wheel Nuts - Clarification of Torque Specification



This Technical Bullentin contains data which supersedes information previously published in some Owner Literature.



Issue:



Some Owner's literature contains an incorrect torque specification for the wheel nuts.



Action:



1. When checking the torque of road wheel nuts on all S-TYPE vehicles, ensure that the nuts are tightened to:



128 + 10 Nm (94 + 7.5 lb.ft.)



2. If removing and refitting roadwheels, observe the detail in Technical Bulletin S 204-01 (Corrosion Prevention - Wheels & Hubs - Grease



Contact Surfaces) prior to refitting. Tighten the road wheel nuts in the order shown in Illustration 1.



Torque the nuts to:



128 + 10 Nm (94 + 7.5 lb.ft.)



The nut and stud threads must be in good condition, clean, dry and ungreased.



Warranty Information:



This Technical Bulletin is for technical information only.

Labels:

Comments

Post a Comment

Popular posts from this blog

Integrated Control Panel (FCDIM)

Integrated Control Panel (FCDIM) Diagnostic Trouble Code (DTC) Index Integrated Control Panel (FCDIM) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. 2012 Jaguar XJ (X351) V8-5.0L SC   284 NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed
Post a Comment
Read more

Adaptive Damping Module (SUMB)

Adaptive Damping Module (SUMB) Diagnostic Trouble Code (DTC) Index Adaptive Damping Module (SUMB) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra
Post a Comment
Read more