Jaguar XF (X250) V8-5.0L SC Technical Service Bulletin # JTB002062 Date: 120213
Body - Trunk Lid Corrosion Prevention
JTB00206NAS2
13 FEB 2012
ISSUE 2 CHANGES ARE HIGHLIGHTED IN GRAY
SECTION: 501
Luggage Compartment Lid Corrosion Prevention
AFFECTED VEHICLE RANGE
CONDITION SUMMARY:
Situation:
Corrosion around the luggage compartment lid plinth may be evident. This may be caused by plinth fretting damaging the paint leading to corrosion.
Action:
In the event of a customer concern of the above, refer to the Repair Procedure outlined below to protect the luggage compartment lid.
PARTS
TOOLS:
26
Refer to Workshop Manual for any required special tools
WARRANTY
REPAIR PROCEDURE
INSPECT / REPAIR LUGGAGE COMPARTMENT LID
1. Inspect for corrosion on the luggage compartment lid. Repair according to Jaguar Paint standards (to be claimed as a separate Warranty Claim).
2. To prevent corrosion re-occurrence, fit protective tape as follows:
^ Using suitable tape, mark the installed position of the luggage compartment lid upper trim finisher.
^ Attach a strip of tape 1.5 mm +/- 0.5 mm above the luggage compartment lid molding.
^ Attach a strip of tape 1.5 mm +/- 0.5 mm below the luggage compartment lid molding.
27
CAUTION:
Remove and refit the luggage compartment finisher carefully, ensuring the seven fixings do not damage the paint.
3. Refer Workshop Manual, section 417-01: Rear Fog Lamp, and remove both rear fog lamps.
CAUTION:
Protection film must overlap finisher top and bottom (1.5 mm) to provide the correct level of abrasion resistance to prevent future corrosion.
NOTE:
Ensure that the surface is clean and free from dust and grease.
NOTE:
Ensure that no air bubbles are trapped under the surface of the tape
NOTE:
Ensure that the upper section of clear tape extends at least 10 mm under the installed position of the fog lamps.
4. Apply protective tape:
^ Apply the clear tape to the luggage compartment lid directly below the upper alignment tape.
^ Apply the clear tape to the luggage compartment lid directly above the lower alignment tape.
^ Trim the lower strip of clear tape to match the profile of the luggage compartment lid.
5. Remove the two strips of alignment tape.
^ Wipe the surface clean.
28
NOTE:
The rubber pad service kit contains 54 buffers in sheet form. The remaining buffers should be retained for subsequent vehicles.
6. Install rubber pads:
^ Cut two of the pads from the Rubber Pad Service Kit (C2Z17715) in half.
^ Install one half pad at each outboard end.
^ Install one half pad in the centre.
^ Install two full pads to either side of the center.
7. Refer Workshop Manual, section 417-01: Rear Fog Lamp, and install both rear fog lamps.