Jaguar XF (X250) V8-5.0L SC Technical Service Bulletin # JTB001862 Date: 100129
Audio System - Satellite Radio Station Presets Lost
No.: JTB00186
Issue: 2
Date: 29 JAN 2010
ISSUE '2' CHANGES ARE HIGHLIGHTED IN GRAY AND BY ASTERISKS
SECTION:415
Satellite Digital Audio Receiver System: Loss of Pre-set Stations
AFFECTED VEHICLE RANGE:
CONDITION SUMMARY:
Situation:
During engine start-up, the Satellite Digital Audio Receiver System (SDARS) pre-set stations may be 'erased'. This may be caused by the North Star
chip processing routine.
Action:
In the event of a customer concern of the above, refer to the Repair Procedure outlined below to configure the *SDARS* module.
PARTS:
No parts necessary
TOOLS:
IDS with IDS-DVD119_V8.06 or later and Calibration File 22 or later Jaguar-approved Midtronics Vehicle Power Supply
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.
Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal warranty policy and procedures apply.
REPAIR PROCEDURE
115
*CONFIGURE THE SATELLITE DIGITAL AUDIO RECEIVER SYSTEM MODULE*
CAUTION:
A Jaguar-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during diagnosis / module programming.
1. Connect the Jaguar-approved Midtronics Vehicle Power Supply to the vehicle battery.
NOTE:
IDS must be loaded with IDS-DVD119_V8.06 or later and Calibration File 22 or later.
2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.
3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.
4. From the Session Type selection screen, choose 'Diagnosis'.
5. Select the Selected Symptoms tab, and then select:
Electrical > Information and entertainment system > Entertainment system > Audio > Radio loses pre-set stations
6. Select 'Continue'.
7. Select the 'Recommendations' tab.
8. *From the Recommendations screen select Run to configure the Satellite audio unit module'*.
^ Follow all on-screen instructions to complete this task.
9. Exit the current session.
10. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.
Comments
Post a Comment