Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S910-01 Date: 040201

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S910-01 Date: 040201

Body - Rattle From Trunk

S910-O1

S-TYPE

DATE 07/99

Amended 02/04

MODEL

2000 MY

S-TYPE

VIN

L02123-L06274

Rattle In Trunk - Incorrect Vehicle Jack Retaining Bolt - Service Action S115

Remove and destroy Bulletin S910-01 dated 07/99. Replace with this Bulletin.

This Service Action has been reissued due to low completion rates. The warranty information has been reformatted to DDW format.

2000 Jaguar S-Type (X200) V6-3.0L Page 281

Issue:

S-TYPE vehicles within the above VIN range may have the wrong retaining bolt for correct retention of the vehicle jack. The bolt may be too short,

and may not allow full engagement to secure the jack and associated foam pack containing the towing eye to the floor pan. This condition may cause

a rattle from the luggage compartment.

Action:

At the first service opportunity, install a longer retaining bolt and correctly arrange and, if necessary, relocate the foam pack that houses the towing

eye as described below.

PROCEDURE

1. Release and open the lid of the luggage compartment.

2. Remove the spare tire cover and, where applicable, the foam surround of the spare wheel.

3. Remove the support pad and the spare tire retaining wing nut and washer. Lift out the spare tire.

4. If the retaining bolt for the jack has a downward-pointing cone on its stem, remove and discard the bolt. Remove the jack along with the

molded foam block that stores the towing eye.

5. If necessary, remove and discard any tie strap connecting the jack retaining bolt and the molded foam block.

6. If necessary, rearrange the towing eye correctly in the foam block and correctly position the block in the arms of the jack, as shown in

Illustration 1, between the actuating thread and upper arms of the jack.

7. Ensure that the operating handle is folded into the position shown in Illustration 1.

8. Replace the jack assembly. Discard any retaining bolt that has a cone, pointing downwards, on its stem. Install and tighten the replacement

securing bolt (arrow, Illustration 1), 50 the washer locates against the bend in the jack operating handle.

9. Check that the wheel nut wrench is correctly stored as illustrated.

10. Reinstall the spare tire, washer, retaining nut and support pad.

11. If applicable, reinstall the foam surround followed by the cover.

12. Close the lid of the luggage compartment.

Parts Information

Warranty Information:

2000 Jaguar S-Type (X200) V6-3.0L Page 282

Warranty claims should be submitted quoting program code S115 together with the appropriate option code from the table. This will result in

payment of the stated time and, where applicable, parts/miscellaneous expense codes.

The option that allows for drive in/drive out can only be claimed when the vehicle has been brought in to perform this action alone.

The SROs and parts items listed in the table have been included for information only. There is no requirement to enter the SROs or parts values onto

the claim.

NOTE:

Always perform a DDW claim search first to determine whether this service action has been performed on this vehicle. The "Review Claim

History" function will provide a listing of all claims against the vehicle. If this service action number appears in the program code field, do not

perform this service action.