DisclaimerJaguar XF (X250) V8-5.0L SC Technical Service Bulletin # JTB00209 Date: 101216
Interior - Rattle From Headliner At Sunroof Opening
No: JTB00209
Issue: 1
Date: 16 DEC 2010
SECTION: 501
Headliner Rattle From Roof Opening Panel Aperture
AFFECTED VEHICLE RANGE:
XF (X250)
VIN: R000001-R87967
Model Year: 2009 - 2010
80
CONDITION SUMMARY:
Situation:
A rattle noise may be heard from the headliner at the roof opening panel area. This may be caused by freeplay in the headliner clipping feature.
Action:
In the event of a customer concern of the above refer to the Repair Procedure outlined below to replace the headliner clips and install foam pads.
PARTS:
C2D7817 Foam block Qty: 1
C2Z11576 Headliner clip Qty: 2
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.
Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
Normal Warranty policies and procedures apply
REPAIR PROCEDURE
INSTALL FOAM PADS; REPLACE HEADLINER CLIPS
CAUTION:
Use care to not bend or damage the headliner.
1. Use a suitable trim tool to pull the headliner down at the rear of the roof opening panel aperture: (Figure 1)
^ Release the clips.
NOTE:
The rear center clip has been deleted from VIN R40100 onwards; for vehicles prior to this VIN, remove and discard the rear center clip.
81
2. Remove and discard the headliner clips: (Figure 2)
^ Ensure any debris is removed from between the headlining and roof opening panel.
CAUTION:
Use care to not bend or damage the headliner.
3. Install the two new clips (C2Z11576) into the original left-hand (LH) and right-hand (RH) fixing points of the headliner.
NOTE:
Ensure the foam pads are fitted approximately 1.0cm (0.40 in) away from the clips to allow them to be fully engaged.
4. Cut the foam block (C2D7817) in half (115mm in length [4.5in]). (Figure 3)
5. Position the foam pads centrally in front of the clips:
(Figure 3)
Attach the pads to the headliner.
CAUTION:
Use care to not bend or damage the headliner.
6. Install the headliner to the roof opening panel aperture:
(Figure 4)
82
Ensure the clips are fully engaged.
Comments
Post a Comment