Skip to main content

2013 Blind spot monitoring not working

HI, fitted a used mirror glass to my drivers side mirror, the orange dot does not light on this mirror but is on the passenger side, the display

reports Blind spot monitoring not working.

90% sure it must be the replacement glass but is it possible the System needs to be reset or something to see this replacement glass.Sun, 31 Jan 2021 20:24:53 +0000Jaybee59

---------------------------------------------------------------------------
Visit this link to stop these emails: http://zpr.io/tiQyF

Comments

Post a Comment

Popular posts from this blog

Integrated Control Panel (FCDIM)

Integrated Control Panel (FCDIM) Diagnostic Trouble Code (DTC) Index Integrated Control Panel (FCDIM) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. 2012 Jaguar XJ (X351) V8-5.0L SC   284 NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed
Post a Comment
Read more

Adaptive Damping Module (SUMB)

Adaptive Damping Module (SUMB) Diagnostic Trouble Code (DTC) Index Adaptive Damping Module (SUMB) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra
Post a Comment
Read more