Skip to main content

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # 1-130 Date: 020301

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # 1-130 Date: 020301



WDS - JTP 759/13 Software



1-130



DATE:



03/02



All



MODEL



All



VIN



JTP 759/13WDS Software



ISSUE:



This release note introduces the changes on JTP 759/13. This release is based on JTP 759/12.



All of the reflash software on WDS is only available from one area. From the vehicle configuration tab select "Reprogram existing modules" and



then select the module to be programmed.



VEHICLE COVERAGE



JTP 759/13 software covers the following NAS vehicle ranges shown.



ACTION:



To install the software, turn on the WDS.



At the VIN prompt, insert the JTP 759/13 CD in the drive. The software will begin to load automatically which will take approximately 15 minutes.



In addition, note that at the end of the software installation, the WDS will now perform a scandisk procedure.



Note:



Unlike the PDU, the WDS software CD does not need to remain in the CD drive after it has been installed. All data resides on the hard drive in

Labels:

Comments

Post a Comment

Popular posts from this blog

Integrated Control Panel (FCDIM)

Integrated Control Panel (FCDIM) Diagnostic Trouble Code (DTC) Index Integrated Control Panel (FCDIM) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. 2012 Jaguar XJ (X351) V8-5.0L SC   284 NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed
Post a Comment
Read more

Adaptive Damping Module (SUMB)

Adaptive Damping Module (SUMB) Diagnostic Trouble Code (DTC) Index Adaptive Damping Module (SUMB) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra
Post a Comment
Read more