Skip to main content

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S307-01 Date: 990601

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S307-01 Date: 990601



Shift Lever Interlock - Release Procedure



S307-01



DATE 6/99



MODEL



2000 MY-ON S-TYPE



VIN



L00001-ON



Selector Lever (Gear Shift) Interlock - Service Release Procedure



Issue:



On 2000 MY-ON S-TYPE vehicles, the situation could occur that the gear selector lever remains locked in the 'P' position. While a discharged



battery might be the primary cause of such a concern, other electrical malfunctions could also result in the same situation.



The following procedure will allow manual release of the interlock mechanism, allowing 'N' to be selected so that the vehicle may be moved or



towed.



Action:



1. Pull hand brake into tully up position.



2. Release the hand brake trim snap.



3. Lift center console lid.



2000 Jaguar S-Type (X200) V6-3.0L Page 283



Caution:



When raising/lowering the upper console, be careful not to damage the plastic trim around the selector opening.



4. Lift upper console from the rear to gain access to the selector lever interlock manual release (Illustration 1). Recover the 7 clips that secure the



upper console to the lower console for reassembly.



5. Slide hand under the right side of console and raise manual release plunger (Illustration 1).



6. While holding plunger in raised position, move gear selector lever from 'P' to 'N'.



7. Reinstall the 7 clips onto the upper console and reassemble once the vehicle has been repaired.



Warranty Information:



This Technical Bulletin is issued for information only.

Labels:

Comments

Post a Comment

Popular posts from this blog

Integrated Control Panel (FCDIM)

Integrated Control Panel (FCDIM) Diagnostic Trouble Code (DTC) Index Integrated Control Panel (FCDIM) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. 2012 Jaguar XJ (X351) V8-5.0L SC   284 NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed
Post a Comment
Read more

Adaptive Damping Module (SUMB)

Adaptive Damping Module (SUMB) Diagnostic Trouble Code (DTC) Index Adaptive Damping Module (SUMB) CAUTION: Diagnosis by substitution from a donor vehicle is NOT acceptable. Substitution of control modules does not guarantee confirmation of a fault and may also cause additional faults in the vehicle being checked and/or the donor vehicle. CAUTION: When probing connectors to take measurements in the course of the pinpoint tests, use the adaptor kit, part number 3548-1358-00. NOTE: If the control module or a component is suspect and the vehicle remains under manufacturer warranty, refer to the Warranty Policy and Procedures manual (section B1.2), or determine if any prior approval programme is in operation, prior to the installation of a new module/component. NOTE: Generic scan tools may not read the codes listed, or may read only 5-digit codes. Match the 5 digits from the scan tool to the first 5 digits of the 7-digit code listed to identify the fault (the last 2 digits give extra
Post a Comment
Read more